Vertical Drive Specifications:
-
72 in. stroke
-
Two feed cylinders are located on an axis through the spindle. Hydraulic cylinders have an ID of 3 in and a piston rod diameter of 1-3/4 in
-
Maximum ram pressure of 28,275 lbs. up and 18,650 lbs. down
-
Maximum feed rate of 36.8 ft/min up and 56.6 ft/min down
-
Gear type hydraulic pump, up to 2,000 PSI, 27 GPM
-
Hydraulic controls are furnished for varying the feed rate and pressure for core drilling
The Power Unit is a 300 cu in Ford, 6-cylinder, liquid cooled gasoline industrial engine with 124 gross horsepower.
Hydraulic Hoists (3)
-
7,000 lb. Hydraulic hoist: A single hydraulic lever controls forward rotation, reverse rotation, and speed. Maximum line speed up is 85 ft/min, maximum line speed down is 340 ft/min, with a pulling capacity of 7,000 lbs.
-
3,200 lb Hydraulic hoist: A single hydraulic lever controls forward rotation, reverse rotation, and speed. Maximum line speed is 100 ft/min with a pulling capacity of 3,200 lbs. Hoist assembly includes wire rope and safety hook.
-
1,800 lb Hydraulic Hoist: A single hydraulic lever controls forward rotation, reverse rotation, and speed. Maximum line speed is 200 ft/min with a pulling capacity of 1,800 lbs. Hoist assembly includes wire rope and safety hook.
In-Out Hydraulic Slide Base is hydraulically operated with an 18 in. movement. The hydraulic cylinder has an ID of 3in and a piston rod diameter of 1-3/8 in
The sideways slide base is hydraulically operated with an 18 in movement. The hydraulic cylinder has an ID of 3 in and a piston rod diameter of 1-3/8 in. With the in-out and sideways slide bases, the spindle can be positioned anywhere within a 275 square inch area.
Moyno 3L6 (36 GPM @ 225 PSI) Water pump assembly is hydraulically powered from the drill hydraulic system. Infinite speed control not affected by engine RPM is provided to vary the volume of the pump. Controls for the operation of the pump are mounted on the control panel.
140 lb Automatic SPT Hammer System is hydraulic and lifts a 140 lb weight 30 inches and completely releases the weight for a 30 in free fall. No rope or cable is attached to the weight that might impede its fall. The system has a rate of 50 blows per minute. The tolerance of the fall height is within plus or minus ½ inch. The hammer is mounted on a hydraulic cylinder attached to the drill so that it can easily swing from stored position to an on-hole position. It is hydraulically raised and lowered by a hydraulic cylinder.
150 gal capacity water tank on board. It is all steel constructed and has internal baffles. The tank includes inlet, discharge and drain ports and plumbing to the mud pump.
The hydraulic leveling jacks have a piston travel of 36 in. The diameter of the rams is 4-5/8 in. The jacks are individually controlled from the control panel. The jacks are an inverted design type with the chrome plated piston rods enclosed ata all times. Two jacks located for the rear and one for the front of the vehicle.